> ## Content Index
> Fetch the complete content index at: https://sgpublic.xyz/llms.txt
> Use this file to discover other available public pages before exploring further.

# 记一次 Linux 下网卡启动异常排查
- URL: https://sgpublic.xyz/p/2026/08/6aac9cb1810a480001533622/
- Published: 2026-08-17T07:42:45.000Z
- Updated: 2026-09-18T03:02:01.000Z
- Author: Haven Madray
- Tags: 网络与路由, NAS, #wp-post

> 这篇博客可能写的比较乱，机器连不上网，我整个操作是通过 IPKVM 完成的，无法复制日志，委屈一下读者了。

### 前情提要

我这是一台《NAS》，之前一直都是只装一张显卡，刚刚我尝试装第二张显卡，开机之后发现 NAS 连不上网，于是开始排查之路。

### 排查历程

首先我观察机器连接的交换机，发现交换机对应网口灯都不亮，用各种操作排除了交换机、网线的问题之后，我用 `ip addr` 一看发现网卡 `enp6s0` 是 down 的，用 `lspci` 能找到网卡，说明不是第二张显卡抢走了 PCIe 通道导致网卡无法启动。

然后我尝试用 `ip link set enp6s0 up` 手动 up 网卡，发现是可以启动的，虽然拿到的是本地链路 IPv6，但至少说明网卡硬件是没问题的。

经 AI 提醒，我开始查看 `/etc/network/interfaces`：

```conf
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).

source /etc/network/interfaces.d/*

# The loopback network interface
auto lo
iface lo inet loopback

# The primary network interface
allow-hotplug enp5s0
iface enp5s0 inet dhcp

```

盲生，你发现了华点：这怎么写的 `enp5s0`，我这里网卡接口名称明明是 `enp6s0`？联想到我加了一张显卡，于是我拔掉第二张显卡，开机，接口名称变回 `enp5s0`，正常联网。

于是结论：`enp6s0` 这种命名是根据 PCI 路径自动生成的，加了第二张卡，网卡的 PCI bus 位置发生变化，原本是 `05:00.0`，现在是 `06:00.0`，于是接口名称变化，网卡接口不能被启动，导致无法联网。

### 解决方案

新建文件 `/etc/systemd/network/10-lan0.link`（根据网卡 MAC 地址修改）：

```ini
[Match]
MACAddress=xx:e0:af:ae:xx:xx

[Link]
Name=lan0

```

这样做就能把网卡接口名称固定下来，避免下次又变了又无法联网了。

然后把 `/etc/network/interfaces` 改成：

```conf
auto lan0
iface lan0 inet dhcp

```

重启，联网正常。